Thursday, March 12, 2020

Section: smoke oil
Hours: 6

The instructions for the smoke oil say you get best results if you install the injectors in the longest exhaust pipes which are on cylinders 1 and 4 if you are using the Van's provided exhaust system. I drilled 1/4 inch holes in the exhausts about 1 inch below the temperature probes. You must line up the injectors so the flats on the probe nut parallel the pipe so the injector slot is aligned properly. The hardest part of the job was adding multiple adel clamps to support the lines.


I made a 90 degree clip to attach an adel clamp for supporting the line going to #4. The clip attaches under the lower adel clamp for the brake line.

 I added several adel clamps behind the engine to support the line going to #1.

No comments:

Post a Comment