Section: avionics
Hours: 5
I recently purchased a pitot static toggle valve and a female straight connector from SteinAir. This valve is placed inline of the static line and can be opened in the case that the static ports become blocked (icing, insects, etc). I decided to install the valve on the cable riser panel between the tunnel on the floor and the control panel. I had easy access to the static line there and it will be accessible in an emergency but out of the way otherwise.
I finished the installation by adding a red switch cover to prevent accident switch activation. It also shows at a glance the switch is in the proper position. I made the switch label by printing on a special ink jet transparent label paper. After printing I cut the label to size, removed it from the backing sheet and applied it to the panel.
No comments:
Post a Comment