Wednesday, January 1, 2020

Section: wings
Hours: 4

The standard wiring harnesses are set up for AeroLed nav lights so I had to make modifications to hook up my AeroLeds. I completed rewiring the connector on the wire bundle coming from the fuselage.


Then I connected the remaining lines to the connectors at the ends of the wings.

I ran a twisted pair of black/red wire for the power going to the pitot heat regulator to mitigate interference with the magnetometer. I tied this ground to the root rib just above the other ground. Hopefully this will work- check in later after magnetometer calibration...

No comments:

Post a Comment