Section: avionics
Hours: 5

Our kids went to the in-laws for Christmas this year so I got to spend some time in the garage. I extracted the bent pins from the P1001 connector.

Then I removed the bent pins and crimped on new ones.

The red wire was too short to be able to insert the pin back into the shell so I spliced on an extension.

Here is the shell reassembled after inserting the new pins.

Here is the other side after inserting the shell back into the tray. I'm not sure if this is going to work- as you can see the pins on the right side of the connector look a little wobbly. I won't know until I insert the GTN 650 after reassembling the panel.