Saturday, November 16, 2019

Section: rudder, elevator, horizontal stabilizer
Hours: 6

Today I did a little more sanding and then applied an epoxy skin coat to seal the micro balloons and fill any remaining pores in the gel coat. I used a small foam roller brush to work the epoxy into all the holes and evenly coat the tips. I purchased the roller brush and several packages of rollers at my neighborhood Lowes. I dispose the roller after use.

Here's the parts with the skin coat of epoxy applied. The skin coat has a texture from the roller. When I sand these parts tomorrow, I will know I've gone far enough when the texture just disappears.




No comments:

Post a Comment