Wednesday, November 18, 2015

Section: 17
Hours: 5

I separated the connector strip from the wing tank skins using the cutoff wheel on my Dremel tool. I  then filed and polished the edges of the 4 wing leading edge skins. The landing light ports were fairly jagged but cleaned up nicely with the die grinder / scotch brite wheel.

Gas cap hole polished and deburred.
 Landing light port smoothed and polished.
Tank connector strips cleaned up, final drilled and dimpled for #8 screws.

 Left LE wing skin mounted in cradles ready for next step.

No comments:

Post a Comment